A soft stone crushing plant is designed to process relatively easy-to-crush materials such as limestone, marmar, Gypsum, dolomit, or chalk. These stones have lower hardness (typically Mohs 3-5) compared to hard rocks like granite or basalt. Below is a detailed breakdown of a soft stone crushing plant setup:

1. Key Components of a Soft Stone Crushing Plant
# (1) Peringkat penghancuran utama
- Kursus rahang (Recommended for coarse crushing)
- Mengendalikan saiz suapan yang besar (hingga 1,200 mm).
- Produces output of ~150-300 mm.
- Kesan penghancur (Alternative for softer stones)
- Better for less abrasive materials.

# (2) Peringkat penghancuran sekunder
- Penghancur kon (For medium-hardness stones)
- Produces well-shaped aggregates (~20-70 mm).
- Kesan penghancur (Preferred for softer stones like limestone)
- Provides better cubical shape.

# (3) Tertiary/Fine Crushing Stage (Pilihan)
- Vertical Shaft Impact (Semua orang) Crusher or Hammer Crusher
- Produces sand or fine aggregates (~0-5 mm).

# (4) Pemeriksaan & Penggredan
- Vibrating Screen separates different sizes (mis., 0-5mm, 5-10mm, 10-20mm).

# (5) Sistem Penghantar & Kawalan habuk
- Belt conveyors transport materials between stages.
- Dust suppression systems reduce airborne particles.

2. Typical Flow Process
1. Memberi makan: Raw material is loaded into a hopper via an excavator or wheel loader.
2. Penghancuran utama: Jaw crusher reduces large chunks to ~150-300 mm.
3. Menghancurkan sekunder: Cone/impact crusher further breaks down to ~20-70 mm.
4. Pemeriksaan: Separates aggregates into required sizes; oversize goes back for recrushing.
5. (Pilihan) Sand Making: VSI crusher produces fine sand if needed.

3. Recommended Equipment Selection
| Bahan | Penghancur utama | Penghancur sekunder | Fine Crusher |
|-|-||-|
| Batu kapur | Jaw Crus